Ceiling Fan Remote Control Not Working

Rarely another electronic device may interfere with the ceiling fan frequencies which may prevent normal operations from occurring.

Ceiling fan remote control not working.

If you are using a remote control check that the batteries are installed properly and are not dead. Usually they consist of a remote receiver wired to the fan inside the ceiling canopy and the fan will still have a pullchain that is not used. The troubleshooting to try is common as it applies to different fans. Turn of the unit using the remote if the power button is working press the off button on the fan for about 10 seconds wait for about another 20 seconds and then turn the fan on again using the remote this will reset the remote and deliver smooth operation.

Troubleshooting a remote is a more common issue as it applies to most ceiling fans not just harbor breeze ceiling fans. Check that the dip switches on the remote and receiver are set to the same frequency. Once you purchase a new remote go through the necessary steps to set it up. If you re using a wall control check the power to the breaker from your control and try working your ceiling fan manually.

If your hampton bay ceiling fan remote is not working there are some standard troubleshooting steps you can go through in order to determine the problem. If this is the case then the receiver can be removed and replaced with another remote receiver kit or the fan can be operated as standard with the 3 speed pullchain. Remotes can stop working for a variety of reasons. The solution is to press the fan high button and then light on on the remote control unit and then pull the pull chains until the light comes on and the fan runs on high.

Ceiling fan remote controls use frequencies to transmit signals which activate the ceiling fan motor and the ceiling fan light. There are some steps to try troubleshooting the remote. So if the pull chain is in the off position the remote control will not be able to get any power to the ceiling fan light or fan.